Rug Doctor Hinge Plate Rivet Replacement

Written By: Arthur Shi
  • Comments: 1
Rug Doctor Hinge Plate Rivet Replacement

Difficulty

Moderate

Steps

6

Time Required

10 - 20 minutes

Introduction

The handle hinge plate is attached to the Rug Doctor via four rivets and two Phillips screws. If any rivets are loose or missing, follow this guide to replace them.

Depending on which rivet you’re replacing, you may not need to remove the handle. If that’s the case, skip the first four steps.

Optional tools:

  • 7/16” wrench (optional)
  • 7/16” socket (optional)
  • pliers (optional)

  1. yHVpmR6vcvKFYF3x

    • Before you begin disassembly, make sure that the Rug Doctor is not plugged in and that all reservoirs are empty of liquids.

    • Unclip the clear hose from the back of the Rug Doctor.

    Include the part number of the c shaped plate.

    JAMES -

  2. qsfWEOHmXGF1xEWO
    qsfWEOHmXGF1xEWO
    ZmYaR5vWrwOa2m62

    • Use a 7/16" (11 mm OK) wrench to hold the handle axle while you use a 7/16" socket to remove the cap nut securing the axle end.

  3. dke3rWFJ2AEmTiJW
    dke3rWFJ2AEmTiJW
    e5UxIKSmKHVdAEsF

    • Support the handle with one hand. It will be loose after this step.

    • Use fingers or pliers to pull out the handle axle.

    • If the axle feels hard to pull out, squeeze the handle release lever to release pressure on the axle.

  4. NnkjsnZHN3nh5Ow4

    • Detach the handle from the Rug Doctor and set it down.

    • If you need more cable slack, you can set the Rug Doctor on its side.

  5. njMToKvyfhoSYCxJ
    njMToKvyfhoSYCxJ
    1VbgtIQXBF32TylV
    mlbQaP4sYsAFVrmV

    • This step shows how to drill a rivet out.

    • Center a sharp 3/16" drill bit on the rivet head's indentation.

    • Drill at slow to medium speed while applying steady pressure.

    • Drill about 1/3" deep—enough to drill past the rivet head and into the shaft.

    • Use a center punch and mallet to tap the shaft away from the head. Remove the rivet head.

    • You may not be able to retrieve the rivet shaft. This is normal.

  6. Tbx2AamJevcBEAIp
    Tbx2AamJevcBEAIp
    lrUlYlGpAN6iKujM
    pIAIHR1tSRtQEOZT

    • This step shows how to install a pop rivet using a rivet gun.

    • Fully insert the stem of a 3/16" (5 mm) pop rivet into the rivet gun. The rivet gun should have a 3/16" adapter.

    • Insert the other end of the rivet into the hole.

    • Press the rivet gun firmly against the hinge plate.

    • Squeeze the rivet gun's handle completely closed. Repeat until the rivet stem breaks off.

Conclusion

To reassemble your device, follow these instructions in reverse order while noting the re-assembly tips.

Author

Arthur Shi

Member since: 03/01/18

248651 Reputation

0 comments