Rosewill NEON M62 Sensor Cover Replacement

Written By: Sean Turk
  • Comments: 0
Rosewill NEON M62 Sensor Cover Replacement

Difficulty

Moderate

Steps

5

Time Required

8 - 10 minutes

Introduction

This guide explains how to remove the plastic sensor cover in the Rosewill NEON M62 mouse. This should be done if the mouse is plugged into a computer, when the mouse is moved, the cursor does not respond.

  1. sCWWMNXZ1ISW2Eb3

    • Place the mouse so the bottom is facing upwards.

    • Remove the rubber skates.

    • These are not shown in the picture since they were missing from the device.

    • Remove the two 5 mm screws with a Phillips #00 screwdriver.

  2. DqR5tgX1LeEHdFpg

    • Use the opening tool along the side of the mouse to open up it.

    • This may take multiple attempts to do so; be patient and careful not to break the mouse.

  3. kPcPjqwM5LFOUNB4
    kPcPjqwM5LFOUNB4
    Hrg3CnCQKRmDnUUb

    • Loosen the top and bottom half of the mouse with the opening tool, and slowly pull up the bottom half of the mouse.

  4. UOECfCRmDDUfe5TE

    • Remove the four 5 mm screws with a Philips #00 screwdriver.

  5. GVmW5NgSwcefvqAu
    GVmW5NgSwcefvqAu
    D5COG5JCEuqhOqQF

    • Remove the center clear plastic piece, known as the sensor cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sean Turk

Member since: 16/03/23

217 Reputation

0 comments