Rival Crock Pot 3120 Disassembly

Written By: Cole J. Morrel

Comments: 2

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

This guide will show you how to disassemble a Rival Crock Pot model 3120. None of the components in the device are extremely fragile, but you should still be careful while performing the steps in this guide. Make sure before starting that your device is not plugged in, and that if it was turned on ensure it has had time to cool down fully. The only tools required are a 10mm and 16mm wrench, but an adjustable wrench or pliers could be used instead. This guide may be helpful for accessing the rotary switch of it is faulty or for replacing the heating element(s) if it burns out. The crock pot has a very simple design and very few components, so repairs should be straightforward.

Tools

Adjustable Wrench

Step 1

Remove the lid from the crockpot and turn the device over, so that the bottom faces up.

Step 2

Use your fingers to remove the rubber end cap from the bolt on the bottom of the device.

Step 3

Using a 10mm wrench, remove the metal nut on the bottom of the device.
If the bolt connected to the nut appeared to fall into the device this is not an issue. It is connected to a metal bar within the device, so it cannot be lost.

Step 4

Using your hands, pull the plastic dial off the side of the device.

Step 5

Remove the nut behind the dial using a 16mm wrench.
Once the nut has been loosened you can finish unscrewing it with your hand.

Step 6

Remove the bottom panel using your hands.

Step 7

Slide the power cord out of its slot in the metal casing.

Step 8

Pull the rotary switch out from inside the metal casing.

Step 9

Slide the metal casing up and away from the internal components of the device.

Step 10

You have now successfully disassembled your device. From here you can troubleshoot or replace any specific parts.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Cole J. Morrel

Member since: 14/09/22

181 Reputation

2 comments

Reassembly is difficult, the bolt on the bottom is too short!

Johnb -

Bolt is way too short to reassemble this thing and I'm not strong enough to bend the wire bail no matter how I try to do it. Never should have taken the thing apart.

Bob Hodge -