Introduction

The trigger mechanism can jam or become less responsive overtime. This is due to over use.

  1. SMlIfTCSJayvWQFF
    • Remove the seven 2.5 mm screws on the top of the sander using the Torx T15 screwdriver.

  2. JIbJ56J1vZLCVBam
    • Remove the top of the sander and put to the side.

  3. eI1C4KtFHnxEIiae
    • Use the screwdriver to unscrew the two #6-19 X 5/8 in screws holding down the outlet cord.

  4. RSRXKCCHmJwvublR
    • Remove the cord from the handle.

  5. bdsO3e1ZlcGnD6Ca
    • Remove the outer plastic piece holding down the white and black wires.

  6. JKBSPYhx5iD5Ie3M
    • Unplug the two connecting pieces that hold wires.

  7. Ph4YFt1GLcdJJe2C
    • Using the screwdrivers, unscrew the four #6-19 X 5/8 in screws on rectangular block.

  8. YFtK2OYSs53OT5BM
    • Remove the black and white wires by pulling out.

  9. eaQmnJJMD1MHjF6n
    • Put the screwdriver in the holes to release remaining two wires.

  10. e2NKgQ4FHNciuQ6S
    • Remove the two remaining wires from switch, leaving the switch freed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ana

Member since: 16/01/19

384 Reputation

0 comments