Introduction

The hook and loop can wear down over time, which is completely normal due to constant use. The replacement parts for this guide can be easily purchased.

  1. 3eNeKnjQHYbkrmXS
    • Flip the sander on its side to expose the bottom.

  2. GCbpJmJkOgNeHDRg
    • Remove the four 2.5 mm Phillips #1 screws with the flathead screwdriver.

  3. jL6mZKt6QMRpfyHg
    • Remove the hook and loop backing pad from the sander.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Luke Stokes

Member since: 16/01/19

464 Reputation

0 comments