Introduction

Most super 8 cameras come with two sets of batteries, one to run the basic motors and the other is the electric eye battery. This runs the cameras “Electric Eye”.

The first “Electric Eye” to be applied to a camera was initially developed by Dr. Albert Einstein and Dr. Gustav Bucky. This technology automatically determined the correct aperture and exposure a camera should use for what it was shooting.

The Ricoh Super 8 800z comes with this automatic technology and will periodically need the battery replaced. When this battery dies you’ll notice the camera not running or footage being over/under-exposed. The Ricoh Super 8 800z also comes with an eye battery test meter, another method to evaluate the battery.

  1. LlqA3sQOOcWKXm2h
    LlqA3sQOOcWKXm2h
    D6ULWynnDUIDd6kT
    • First, check if the battery is still working.

    • The Ricoh Super 8 800z comes with two battery meters in the back side of the camera. The button labeled "MOTOR" tests the AA batteries in the handle. Pressing the "METER" button will test the eye battery.

    • Press the "METER" button. If the needle on the gauge above goes to red, the battery is dead and needs replacing. If it is on blue, the battery is working and does not need replacement.

  2. 2sVYchPURAbEX1BZ
    2sVYchPURAbEX1BZ
    mMGYFtyXlBRXiRUW
    AZmaWLcZjN5GUyd5
    • To remove this eye battery cover, place the camera on soft and stable surface, apply even and firm pressure around the metal cap, and unscrew it counter-clockwise.

    • The cover for the eye battery is the circular and ridged metal cap on the back-most part of the left fascia.

    • If it does not unscrew with your hand alone, you can use pliers and cloth to loosen it. Place a small cloth rag on top of the cap, grab the sides of the cap with the pliers, making sure to keep the cloth between the pliers and the camera to avoid tooling marks and any damage. Turn counter-clockwise until the cap loosens. Then unscrew by hand.

    It should read, “To remove this cap, place the camera on soft and stable surface and apply even and firm pressure around the metal cap; it will unscrew counter-clockwise.

    John Lamothe -

    It should read, “Place a small cloth rag on top of the cap and grab the sides of the cap with the pliers, making sure to keep the cloth between the pliers and the camera to avoid tooling marks and any damage. Turn counter-clockwise until the cap loosens and then unscrew by hand.

    John Lamothe -

  3. SSWWH3vC5TkvZ4x2
    SSWWH3vC5TkvZ4x2
    NMSisBL1wJacoj1F
    qEu42jBsy5US6Spx
    • To remove the battery, simply turn the camera over with the open battery port facing down over a soft surface. Gravity should drop it out.

    • If it is stuck, just lightly tap the opposite side of the camera until it releases.

  4. VhY5MwoahxXWqjgB
    VhY5MwoahxXWqjgB
    mGPGOIXZXyYLOy5I
    • If your battery port happens to be corroded. Get a small cloth rag held with small needle nose pliers or tweezers and wipe it away.

    • For heavy amounts of corrosion use a little bit of vinegar on the cloth and use to remove. Wipe the vinegar away after with a clean and dry cloth.

    • Allow the battery terminal to sit open and dry for an hour or so if vinegar is used.

Conclusion

To reassemble your device, follow these instructions in reverse order.

carlos enrique

Member since: 30/01/20

335 Reputation

0 comments