Introduction
If the zooming lens of your Ricoh Shotmaster 130Z camera is broken or malfunctioning, this guide will show you how to replace it step-by-step.
-
-
Remove the 5mm JIS #00 screws from the bottom of the camera.
-
Pay attention to the 6mm screws on the sides of the tripod slot, as they are a slightly different size from the rest of the screws. However, you still may use a J00 screwdriver to remove them.
-
-
-
Using an opening tool, lift the case of the tripod slot (on the bottom) until the back portion of the case is released.
-
Continue to use the the opening tool to insert it and lift right next to the strap of the camera.
-
-
-
Use a JIS #0 screwdriver to remove the three marked screws found around the perimeter of the lens.
-
-
-
Proceed to remove the two screws using a JIS #00 screwdriver.
-
Use tweezers to lift the lens off of the board.
-
To reassemble your device, follow these instructions in reverse order.
