Replacing the Battery of the Fujitsu Primergy

Written By: Marc developer
  • Comments: 0
Replacing the Battery of the Fujitsu Primergy

Difficulty

Easy

Steps

4

Time Required

2 minutes

Introduction

Not even a screw is required to change the bios battery.

By replacing the CMOS battery the setting will be erased and set by default, in case of problems with the bios its common practice to remove and reinsert the battery to reset it.

  1. Pc44LRnKXixjLVaY

    • Pull the green tab on the side and pull back the panel

    • Remove the panel and store it somewhere

    • On page 37 of the manual there is a description similar to that of this article

  2. wEpMGOVlmblksNUO

    • Press the two green tabs and pull up the fan on the CPUs

    • Be careful to take it easy, the fan cable is short (red arrow)

  3. Wa5c3NTL2RiWYYZN
    Wa5c3NTL2RiWYYZN
    Wa2rRyjouPutgUfS

    • Press on the green clips

    • Slowly pull the cards out of the slots

    • It would be advisable to connect to the ground first

  4. sJMoArcbRYledyeC
    sJMoArcbRYledyeC
    gBYieQSjDgV1wuPJ

    • Press on the clip (in red) and the battery should come out by itself

    • Insert the new battery

    • Check the polarity, usually the writings must be upwards

Conclusion

By replacing the CMOS battery the settings should remain saved

Author

Marc developer

Member since: 16/08/21

1336 Reputation

0 comments