Replace Kärcher RC3000 brush motor. replacement

Remove both batteries.

Remove protective rubber collision protection and cover.

Unplug the on/off switch.

Unplug the connector for the charging contacts.

remove pins. Caution, risk of injury for the inexperienced.

Detach outer upper case (do not remove yet!). To do this, loosen 4 screws. With slotted screwdriver or 8 Torx.

rotate device. Hold both frames. Be careful, the screws will fall out. 4 left?

Now carefully remove the upper cover without pressing the lower part down. Then the springs remain mounted!

Disconnect the brush motor connector.

..and the others on the site too.

Remove brush motor.

Congratulations, mountain party

Install new brush motor.

plug in.

...put on more plugs.

Check the sensors for correct seating

Put the top lid on. Make sure that the cover is assembled without using force!

rotate device. Hold the two frame parts together well.

Do the sensors sit well in the frame?

The pins that must hold the spring must dip into the opposite frame part.

Only then can the frame be screwed on on this side.

The same on the other side.

Also install the remaining two screws. When tightening, ensure that the frames are evenly spaced apart.

Reinsert the pins for the brush from the correct side.

Insert pins to the end.

Install brush

attach the cover

rotate device

Plug in the connector for the charging contacts

Plug for the on/off switch..

Mount the yellow cover

Mount the bumper

Install batteries

Testing