Removing HP Compaq dx2000MT Power Supply

Written By: Logan Pace
  • Comments: 1
Removing HP Compaq dx2000MT Power Supply

Difficulty

Moderate

Steps

8

Time Required

No estimate

Introduction

This guide will show you how to remove the power supply on your HP Compaq dx2000MT.

  1. QqUIfbEFgWEoENc2

    • Turn off your computer and remove the power cable by pulling it straight out of its socket.

  2. TZBMYGU5xmCouAHI
    TZBMYGU5xmCouAHI
    XXkhfrfYF5k3YXoN

    • Remove the two Phillips #2 screws that secure the case door to the device.

  3. 3OpvPkfn4SA6ynv3
    3OpvPkfn4SA6ynv3
    UuZilQWYmFN4VQTC
    NEhXURB4ZrJWoWTA

    • Remove the side case door by pushing towards the rear of the device with your hand.

    • This may take considerable force so keep pushing!

    • Once you slide the door back, remove it by pulling it outwards from the device.

  4. N5AQDkScGdcXVN1O
    N5AQDkScGdcXVN1O
    VeMOUrXheEXxLxBu
    cFBdm1RJSZlEaPYp

    • Remove the side case door by pushing towards the rear of the device with your hand.

    • Once again, this may take considerable force.

    • Once you slide the door back, remove it by pulling it outwards from the device.

    it’s useless my friends

    bisous sur les fesses de ta mamaa

    Albert einstein -

  5. UqVF4gNtxbDnQyYS
    UqVF4gNtxbDnQyYS
    J2PHexnktjs3MB63
    1FoQZkfGZAydiaeq

    • Remove the 4 pin ATX power connector from the motherboard by pressing down the holding latch and pulling out towards the side of the device.

  6. qLyEGMCW3sAiMfAN
    qLyEGMCW3sAiMfAN
    v5EjSXqDkCEH46Pr

    • Remove the 20 pin ATX power connector from the motherboard by pressing down the holding latch and pulling out towards the side of the device.

  7. yiqLCmNxChORDchq
    yiqLCmNxChORDchq
    n2UU4qHnJUojYeON
    1op5BlXCKkZnsCqA

    • Remove the 4 Torx T15 screws from the rear of the power supply

  8. 1SBhDpYyxENXK5br
    1SBhDpYyxENXK5br
    rF6DNHS2TPDOOtxK

    • Slide the power supply towards the front of the device

    • Keep your hand underneath it! You don't want to drop it!

    • Then pull the power supply down and remove it from the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Logan Pace

Member since: 12/10/11

2224 Reputation

0 comments