Razer Deathadder V3 Pro Skates (Feet) Replacement

Written By: Swrlz
  • Comments: 0
Razer Deathadder V3 Pro Skates (Feet) Replacement

Difficulty

Easy

Steps

8

Time Required

5 - 10 minutes

Introduction

  1. sM6SGVCnq14MRJSE
    sM6SGVCnq14MRJSE
    vBUHDCmPfyDILQr5

    • Turn off the mouse by holding the power button for 3 seconds.

    • The light on top will blink red, indicating its been turned off.

  2. ueGOQSORUhr14QCl

    • The Deathadder V3 Pro has 4 individual skates on it.

  3. I5n2OJNP4ACOjD2R
    I5n2OJNP4ACOjD2R
    TELDORNdkJlC2CeZ
    ibPWsESdnonZaPUh

    • Slide your fingernail or a pair of tweezers under the skates and pull up.

    • I found using my finger to finish peeling the skates off was easier, but your mileage may vary.

    • Be careful around the sensor as you could potentially damage it and cause unwanted tracking issues.

  4. Rgtaq1RpPIUxf6hZ
    Rgtaq1RpPIUxf6hZ
    VGIiQ4oSsBZhKcvW
    iDg1KRpaJvtxoRsG

    • If there is a leftover paper like material, remove it just like you did the skates.

  5. 1WBnb52i4enEepVF
    1WBnb52i4enEepVF
    uFBeofGq6ZnnWTOi
    m4XEyNkUSUV6kj6F

    • Use the included alcohol prep pad, or your own, to remove any leftover residue.

    • You might have to use your finger to remove some stubborn residue.

    • Let the alcohol dry for a little before continuing.

  6. mSZlgjliV1VhjW5l
    mSZlgjliV1VhjW5l
    nTwSQMc3pjAYSydw
    ia1tP3NPTkLNOdwf

    • Place your new skates in the correct spot.

    • Apply some pressure with your thumb to make sure that the skates stick properly.

    • Do this for all of them except the sensor ring, that one is discussed in the next step.

  7. iAaYL2MdnABvWEFK
    iAaYL2MdnABvWEFK
    bJNZIveHRPQdsnHn
    bGmFQ45Jg64NmySB

    • Use your tweezers or fingers to pop out the extra piece for the sensor ring.

    • When placing the sensor ring skate, be careful not to damage the actual sensor.

  8. dnwbnbtangCYasLU

    • Enjoy your new mouse skates!

Author

Swrlz

Member since: 13/02/23

157 Reputation

0 comments