Razer Deathadder Elite Feet And Grips Replacement

Written By: David Cedrone
  • Comments: 1
Razer Deathadder Elite Feet And Grips Replacement

Difficulty

Easy

Steps

6

Time Required

10 - 15 minutes

Introduction

If your Razer Deathadder Elite is not gliding well on a mouse pad and/or the mouse grips are no longer staying in place, use this guide to replace the mouse feet and grips.

The mouse's feet help the mouse glide on a surface. Overused mouse feet produce skipping and uneven gliding. The mouse grips help provide the user with more precise mouse movements. If these are damaged, the mouse is not as accurate.

Before using this guide, check to see if dirt buildup on the mouse feet is causing skipping or uneven gliding.

Before starting this guide, make sure to fully unplug the mouse from any external power source.

  1. AZ4RMHIktKAZRPTx
    AZ4RMHIktKAZRPTx
    b3dgkxP3YRrxyZyh
    wBbsGbsjdybmHX5o

    • Peel the mouse foot away with the tweezers. Repeat for all the mouse feet.

  2. p4fEXJLAYpPoMnuf
    p4fEXJLAYpPoMnuf
    SlDAfgcIKoGUW1bw
    KMrNhMCWWnBQioXr

    • Apply isopropyl alcohol to each of the areas where the mouse feet were.

  3. t2vltalLGX1xjXcr
    t2vltalLGX1xjXcr
    1kivKVrQtvfU5NEM
    VayVgqRbXCHEmyER

    • Peel the replacement foot away from the sticky paper and make sure to not touch any of the glue underneath.

    • Align one of the edges of the replacement foot and with the mouse.

    • Place the foot onto the mouse and apply pressure for one minute so the glue sets.

  4. kklkhsCppWOjhcaT
    kklkhsCppWOjhcaT
    o2X4BGZrBlpZKsQH
    WM6D64pFCB4GcV3t

    • Lift the white paper/film off of the back of the mouse foot with a pair of tweezers to ensure proper gliding on the mouse pad. Repeat for each of the mouse feet.

  5. 3uUafa5tCQ2uAmPB
    3uUafa5tCQ2uAmPB
    ZSQLJCiPtHHTHZ2m
    aKLKPIyEu1niixmV

    • Rotate the mouse 90 degrees counterclockwise and peel away the old mouse grips.

  6. GiqVHAXvf2CMKU3F
    GiqVHAXvf2CMKU3F
    6ABoLcBLqYynMhI5
    rQnKiTuUjkee5hPO

    • Peel away the grip from the sticky paper.

    • Potential for device damage: Do not touch the bottom of the grip, otherwise the glue will be less effective.

    • Align one of the edges of the grip with the corresponding edge on the mouse and press firmly on it for 30 seconds once placed.

Author

David Cedrone

Member since: 22/03/21

165 Reputation

One comment

Fantastic. thanks for the guide. Much easier than what I was going to do.

HIS -