Razer DeathAdder V2 Pro Battery Replacement

Written By: Tatiana Nzeba
  • Comments: 3
Razer DeathAdder V2 Pro Battery Replacement

Difficulty

Moderate

Steps

8

Time Required

5 - 10 minutes

Introduction

Use this guide to replace the battery in a Razer DeathAdder V2 Pro. The battery is a very important part of this device as it provides power capacity. Since the Razer DeathAdder V2 is a wireless mouse, it operates with a battery that needs to be charged. However, a frequent use of the mouse and repeated charges will decrease the performance of the battery which will need to be replaced.

No complicated skills or tools are needed to follow this guide.

If you need any other help or more tips on your device go to our troubleshooting guide page.

  1. aIsVDT1jAZ1KKFtT

    • Turn the mouse over so that the writing on the bottom faces up.

  2. qnOuIkFMqm4xIVGs

    • Use a spudger to remove the three pads on the bottom of the mouse.

  3. TReuR3lYGgKJGjY2
    TReuR3lYGgKJGjY2
    yMvlKV4fDjwVrZ32

    • Remove the four 1.2 mm screws from each corner of the mouse using a T6 Torx screwdriver.

  4. KC1Aor41IFaghpoq

    • Use a nylon spudger to pry the back cover away from the mouse.

    • Starting from the lower corner of the mouse is strongly recommended. Once the tool is in, slide it in between the top and the lower part of the mouse, and run it around the edge of the bottom cover until it pops out naturally.

    • Be cautious not to crack the top and the bottom covers of the mouse.

  5. i3AvjRNF4lsy5KUH

    • Detach the white connector with red wires gently from the side that connects the side buttons to the PCB.

    • Be careful not to pull too hard on the connector to avoid damaging the solder that connects to the PCB.

  6. xL4cKIxW2kHFYlNF

    • Make sure the PCB is disconnected as shown before pulling apart the two halves of the mouse.

  7. w2sdX1LBFigc1thl

    • Place both the top and bottom pieces of the mouse on their backs.

  8. VHZFjfWu4hHEjjFL

    • Remove the three 1 mm screws that hold the battery to the circuit board using a Phillips #1 screwdriver.

    • Remove the battery from the mouse.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tatiana Nzeba

Member since: 15/09/22

160 Reputation

3 comments

What Voltage and mAh is the battery?

Nicoolodion -

AliExpress ex. has the apropriate battery for this mouse.

It´s a battery with 1500mAh and 3,7V .

Claus Gärtner -

Are you referring to LOSONCOER?

pikimouse -