RIDGID R32104 Saw Blade Replacement

Written By: Lucas Pimentel
  • Comments: 0
RIDGID R32104 Saw Blade Replacement

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

If the blade on your Worn Drive Saw suddenly stops, makes improper cuts, or you experience kickback, the blade is faulty or is misaligned. Use this guide to remove or realign the blade. You just need a H-6 mm Allen Key, in order to remove one type of screw in the replacement process.

  1. KHxRJEr5nfWujAmM

    • Turn off your saw and unplug before starting.

    • The RIDGID R32104 Saw did not come with a blade, so paper was used to mime the actions needed.

    • Place the Worm Drive Saw on a sturdy surface.

    • The blade is located within its upper blade guard and lower swing guard assembly.

  2. cSJrvqJO5FUTCaCH
    cSJrvqJO5FUTCaCH
    mVsfkKtFkdY5qRiP

    • Using a H-6 mm Allen Key, remove the 3/8 - 16 UNC LH screw, washer, and outer blade washer that fixes the blade in place.

    • In order to unscrew this, you must turn the screw clockwise to loosen it.

  3. MCFTJdLunJRuyWrd

    • Adjust the lower swing guard to properly grab the blade.

  4. 31ngATIFgBVjBvPI

    • Remove the blade by gingerly grabbing towards its center, preventing any injury from occurring.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Lucas Pimentel

Member since: 02/04/19

1010 Reputation

0 comments