Introduction

Replacing the onboard speaker for the RCA CC310.

  1. HeZEXwM2sRWiGMvR
    HeZEXwM2sRWiGMvR
    1lUxaOJDvH3XcBKa
    • Remove the six 7.9mm Phillips #0 screws on the back and bottom.

    • Remove the one 3.8mm Phillips #0 screw on the bottom.

    • Remove the two 7.5mm Phillips #0 screws on the back and bottom.

  2. p2UtppAT1HrZEpQ3
    p2UtppAT1HrZEpQ3
    S4wmGQhsLVO5RcMK
    • Remove 5.8mm Phillips #1 screw from the side button panel.

    • Slide the viewfinder all the way to the right and remove the 7.9mm Phillips #0 screw.

  3. 1sWEswjyuTUUhLgU
    1sWEswjyuTUUhLgU
    5NgXWwyFhRAhXOIx
    • Pry along the seam on the top side near the buttons with a spudger.

  4. 4AyCOUiguDMkJeEE
    4AyCOUiguDMkJeEE
    ccjnRcwwVURpRNWx
    • Pull the left panel away from the rest of the camcorder.

    • Unplug the red speaker cable located at the rear of the device.

    • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

  5. QSfagbDRntGCIJOJ
    QSfagbDRntGCIJOJ
    xuqnfgfgafM2gM1S
    • Unplug the red cable connecting the speaker to the motherboard.

  6. XQkXyaVUDmeoPiNf
    XQkXyaVUDmeoPiNf
    1qoFTX2QLkE4Mn65
    • Locate the speaker on the removed panel. Find the groove on the top left side of the speaker.

    • Pry the plastic up with a spudger until the glue breaks and the speaker is detached.

  7. Pswiax1OETALqcHY
    • Break the plastic pieces holding the cable to the panel.

    • Glue the new cables, with a hot glue gun, back to the panel after replacing the speaker.

  8. iLAiIYG1RbALuCRM
    iLAiIYG1RbALuCRM
    FZ2HGZQrBkoKKIQf
    ZiRPUweIIemSvX2c
    • Glue the new speaker to the panel.

    • Plug the cable back into the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Oliver Adams

Member since: 19/01/11

629 Reputation

0 comments