Introduction

In case of broken lugs or screw holders, the two housing parts can be glued together. It is important to check that you have assembled everything correctly before gluing.

  1. jv1LnAQp5GMHmsX1
    jv1LnAQp5GMHmsX1
    VSgRwB4pAEYSoK6u
    Q1cOZpRADsrLWUVr
    • Removing the five (TR15) scrapers

  2. wc3hMveQVAHVpsRL
    wc3hMveQVAHVpsRL
    XRkduNlKHKmQVsIL
    • Removing the first part of the housing

    • Removing the rotary wheel, important pay attention to the black component so that the nose in does not break off (green mark).

    • Removing the second part of the housing

  3. v5EMIcQI3GGTEqY2
    v5EMIcQI3GGTEqY2
    qbqlyVGTG6n6GMpS
    OLMYsRtuhxOyVwWF
    • Make sure that the green marked elements are in the right place in both housings, the red element is only available once.

    • Make sure that the two strands run as marked in blue.

    • The white element must be in the rear position. (marked in orange)

  4. qioL25X36LQDhcxk
    qioL25X36LQDhcxk
    iN2AfJJRlpBtIjfj
    NixgeIOGu1MI4cMs
    • Lift the motor-gearbox-unit a little bit upwards so that you can insert the black element with the nose into the hole of the white element. (marked in green)

    • Insert the nose of the black element into the hole of the rotary switch, making sure it is oriented as shown.

    • Gently move the rotary switch so that it fits into the slot in the housing. (marked in blue)

    • Then you can tighten the upper housing part with the five screws (TR15).

Justus Klingler

Member since: 23/12/20

300 Reputation

0 comments