ProScan PLT7223G Speakers Replacement

Written By: Laura Kneeshaw
  • Comments: 0
ProScan PLT7223G Speakers Replacement

Difficulty

Moderate

Steps

5

Time Required

10 minutes

Introduction

If your ProScan's audio is not working, use this guide to replace the speakers. This guide will require soldering.

  1. FhUraGA2Uc5pyuDJ

    • Remove both 4 mm screws on the top of the tablet with a PH00 screw driver.

  2. DDEWTXw1ciZDKiFL

    • Use the blue plastic opening tool to pry open the tablet.

    • You will hear popping sounds. That's okay.

    • Be careful when using the blue plastic opening tool on the side of the device near the speakers, as there is a wire here that connects the speakers to the motherboard.

  3. aE4F1WITX16rhZ1g

    • Pull back the protective tape from the two wires that connect the speakers to the motherboard.

  4. QW2rCwwEyW1gebAa

    • Use the soldering tool to remove speaker wires from motherboard.

    • Soldering tool will get hot, handle with care.

  5. GnsjNkdqjVYiZXIC
    GnsjNkdqjVYiZXIC
    tHNkjZuHrJienWtB

    • If needed use a plastic opening tool to remove speaker from the speaker port on the tablet.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Laura Kneeshaw

Member since: 13/01/16

435 Reputation

0 comments