PowerLead Puto PLD003 Back Buttons Replacement

Written By: Justin Tew
  • Comments: 0
PowerLead Puto PLD003 Back Buttons Replacement

Difficulty

Moderate

Steps

9

Time Required

15 minutes

Introduction

This guide shows how to remove the screws that hold the camera together, how to remove the side panel from the camera, how to remove the back panel, and how to replace the back buttons.

  1. XyRHeHJxnwPRleEy

    • Slide the battery eject button open to release the battery door.

  2. Ea3Ef2khOWbPZiJD

    • With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

  3. GCCxAR3arAcRJbYL

    • Rotate the camera so that the underside is facing up.

    • Remove the four 5 mm Phillips #1 screws.

  4. BTKFTPjpSFd2M4dp

    • Place the camera on a flat surface, with its underside facing you.

    • Gently pull up on the side panel to remove it from the camera.

  5. XR1A4yPWrVGNaYCc
    XR1A4yPWrVGNaYCc
    SeBcrfTSdrIOrlK2

    • Remove the three 4 mm Phillips #1 screws holding the weight.

    • Remove the weight.

  6. qRkHy5GDXk4WiXCx

    • Remove the two 4 mm Phillips #1 screws holding the back panel in place.

  7. 1IojKNBK21BrRcnd

    • Apply pressure to the back panel, away from the camera to remove.

  8. msWtBkLFJvNADpci
    msWtBkLFJvNADpci
    M6dLc3qPTkuGfu13

    • Place the back panel so the buttons are facing down and the circuit board is facing up.

    • Remove the three 4 mm Phillips #1 screws holding the circuit board in place.

  9. yQyC2a5A34jAcK1w

    • Set aside the circuit board.

    • These nubs are what is currently holding the buttons in place.

    • Carefully apply pressure and remove the set of buttons from the nubs.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Justin Tew

Member since: 31/03/16

767 Reputation

0 comments