Power Macintosh G3 Minitower Processor Module Wire Screw Replacement

Written By: LeoI07
  • Comments: 0
Power Macintosh G3 Minitower Processor Module Wire Screw Replacement

Difficulty

Easy

Steps

4

Time Required

No estimate

Introduction

    • Press the green release button on top of the side access panel.

    • Pull off the side access panel to get inside the computer.

    • When putting the side access panel back on, make sure that the bottom of the panel lines up with the rail on the bottom, and that the chassis is locked with the green latches.

    • Lay the computer on its side, ensuring that where the side access panel was is facing up.

    • Unlock the top chassis by moving the two green locking latches upward and outward.

    • Using the handle, gently swing the top chassis up and out until it rests firmly on the work surface.

    • Using a Phillips screwdriver, unscrew the screw on the logic board holding the processor module wire in place.

    • When screwing down the wire, be careful not to damage the capacitor next to the screw hole.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

LeoI07

Member since: 10/06/21

1573 Reputation

0 comments