Introduction

This guide is applicable to BRIGHT's SunBell 2.0 Y.
If you have a different lamp please find its dedicated guide.

  1. cGrCCHvalAORfiL5
    cGrCCHvalAORfiL5
    saFbyWUjBjQ5HCEA
    • Gently pull apart the two sides of the plastic case. This will reveal the circuit board an battery.

    • Using a Torx 6 Screw driver, loosen and store the 3 screws at the bottom side of the case.

  2. 4AoJFMEHRxn5O5EV
    4AoJFMEHRxn5O5EV
    qfGNCMZSq6SjDqOs
    • Look for the white plastic battery connector at the base of the circuit board.

    • Carefully grip and pull out the white battery connector. If there is silicone or glue be mindful not to apply much force to prevent the entire connector to come loose from circuity board.

    • Keep battery aside.

  3. StgHphdUdgGXCeXs
    StgHphdUdgGXCeXs
    FA1XxRr5pCCFhZBJ
    • Using a Torx 6 scredriver, remove the (2) screws holding the circuit board

    • With the help of a flat tool, pry the circuit board off the plastic case.

  4. TRwgllhfyA14o566
    TRwgllhfyA14o566
    KkeWAU3UqaMmjvbT
    XLR6SukWKfWcNVmk
    • With aid of a pointy tool, push the damaged flexible button from the top down.

    • Using the fingers, insert the new flexible button from the top-down into the case opening. Make sure the button flange is not folded.

Conclusion

To reassemble your device, follow these instructions in reverse order.

BRIGHT Products

Member since: 06/11/23

144 Reputation

0 comments