Introduction
After a period of time, it is possible that the motor in the Porter-Cable PC60TAG may experience issues, requiring replacement. This guide will demonstrate how this is done.
Tools
-
-
Using the Phillips #2 screwdriver, remove the1/2" Phillips screw holding on the motor brush arm. Repeat on the other side.
-
-
-
Carefully pull the motor brush arm away from the other device, you can leave the wire connected to device. Repeat on the other side.
-
-
-
Using the Phillips #2 screwdriver, remove the two, 1/2" screws holding the head to the body on the bottom side of the grinder.
-
-
-
Using the Phillips #2 screwdriver, remove the other two 1/2" screws holding the head to the body on the top side of the grinder.
-
-
-
Holding the head of the device, carefully pull the motor assembly out of the body of the device.
-
To reassemble your device, follow these instructions in reverse order.