Introduction
Removing the electronic motherboard from the base of the Polyconcept Retro Cordless Phone may be a necessity for repair or replacement. This guide will help you disconnect the motherboard from the rest of the device.
-
-
To disconnect the phone cord, squeeze the tab against the connector and pull the cord away from the telephone-line-in-jack.
-
To disconnect the power cord, grasp the end and pull back and away until it is disconnected.
-
Once disconnected remove each cord from its track.
-
-
-
With the base turned upside down, grasp the edges of the base plate and gently lift from the rest of the base.
-
-
-
Use a Phillips #00 screwdriver to remove the three 6mm screws from the phone and power jack cover plate.
-
Lift the phone and power jack cover plate away from the motherboard.
-
-
-
Use the spudger tool to carefully scrape the glue off of the connection points of both the black and red wires.
-
-
-
Gently lift the motherboard away from the base plate and flip over.
-
Use the soldering station to desolder the wire connections.
-
To reassemble your device, follow these instructions in reverse order.
