Philips DC320 37 Speaker Replacement

Written By: Graham Rolph
  • Comments: 0
Philips DC320 37 Speaker Replacement

Difficulty

Easy

Steps

8

Time Required

20 minutes

Introduction

Follow the procedure outlined in this guide to remove and install a speaker.

  1. OJE6iwTF1MfAQKG6

    • Pry off the four white feet with the pointed end of the spudger

  2. V21CawLi2fTRLHrQ

    • Gently unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

  3. EVAJNaADthnDRWtk

    • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

    • The connectors on the panel are fragile and may break.

  4. AC4yGkktpFkIrau5
    AC4yGkktpFkIrau5
    4OAFMGFY6edvpdQ6
    CTAQrEGNPjMJkIUY

    • Carefully pull up and out the four electrical connectors and two ribbon connectors that connect the bottom panel to the dock.

    • Electrical Connectors

    • Ribbon Connectors

    • The cables do not have a lot of slack in them. Be careful not to break the connectors.

    • One wire is soldered onto the bottom panel. Be careful not to break this bond.

  5. 5ZCOZbR6bxYF3GLI

    • Unscrew the two 6 mm Phillips #00 screws attaching the back panel to device.

  6. RaAKHoIEvvQMFjeQ
    RaAKHoIEvvQMFjeQ
    ObdKcvxy6XSyFlLQ
    16xQyEusc6oBtSSf

    • Slide the back panel towards top of the device and lift away from the device to detach back panel.

  7. cGn5vHmdZcSOR1At

    • Unscrew the four 16 mm Phillips #2 screws attaching the speaker unit to device.

  8. rIwrTt1o4yw41CcB
    rIwrTt1o4yw41CcB
    oKqnxeNrDbgKdNPr

    • Slide the speaker towards the bottom of the device to remove.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Graham Rolph

Member since: 18/04/13

1 Reputation

0 comments