Pentax Optio WP Motherboard and Flash Unit Replacement

Written By: Derek
  • Comments: 0
Pentax Optio WP Motherboard and Flash Unit Replacement

Difficulty

Difficult

Steps

4

Time Required

20 - 30 minutes

Introduction

PREREQUISITE GUIDE ONLY.

  1. 13JpA1i2ffAEKC41

    • Remove the 4 mm black screw on the bottom right corner of the mother board.

    • The black screw may be hard to remove. Use the tweezers if necessary.

  2. qHoxjoIYJEZaXMLp

    • With the tweezers, carefully peel back the copper ribbon that was underneath the black screw.

  3. MuuD2Ewi4CnNOHSB

    • Remove the 2.5 mm silver screw from the upper left corner of the motherboard.

  4. 5nnQnwgFSpWypmqk
    5nnQnwgFSpWypmqk
    GxXtBX56hll61Uds

    • Press down on the metal plate and gently lift the motherboard up from left to right.

    • Be cautious when lifting the motherboard since there is a copper ribbon and two wires attaching the motherboard to the flash unit.

    • Reorient the camera so you are looking at the top edge with the metal plate on the right.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Derek

Member since: 22/01/11

746 Reputation

0 comments