Pentax Optio WG-2 Back Case Replacement

Written By: Matthew Bessette
  • Comments: 0
Pentax Optio WG-2 Back Case Replacement

Difficulty

Moderate

Steps

6

Time Required

10 minutes

Introduction

Use this guide to replace the rear case of the Pentax Optio WG-2.

  1. iQMdIOX12rjFiMQl
    iQMdIOX12rjFiMQl
    RRLyZoNftbUQOYXZ

    • Remove all four 1 mm JIS #00 screws from the back of the camera.

  2. XGQ2pdZYn5kTsthu

    • Use your finger to peel the grip off the top of the camera.

    • For best results, start from the right side of the camera, opposite the buttons.

    • Once the grip is removed, you will most likely lose the water-tight seal.

  3. GjcvS4ppoRXOl2TT

    • Use the tweezers to remove the two buttons from the top of the camera.

    • The buttons may fall out while removing the grip.

  4. OpNim4RE1FRnvq1E
    OpNim4RE1FRnvq1E
    w4a1ePCL1LRMHTuI
    fGNJkOmSeAYcJpCE

    • Remove the three 1 mm JIS #000 screws from the top.

    • Remove the 1 mm JIS #000 screw from the bottom.

  5. LfsVsjOXySfmOWni

    • Carefully separate the back and the front of the camera.

    • There are three ribbon cables connecting the two boards. Be careful not to tear them.

  6. aPIJIefXJRsYWARK

    • Use the tip of a spudger to flip up the small retaining flaps on the ribbon cable ZIF connectors.

    • Carefully pull the ribbon cables out of their sockets.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Matthew Bessette

Member since: 04/03/16

658 Reputation

0 comments