Introduction

  1. lttBZeoWIoRGtaun
    lttBZeoWIoRGtaun
    CyRuHEv1FkbVXsxJ
    x6DDoZGxPwpUnxZu
    • Remove Battery and Strap from unit.

    • Remove the 3 screws from the bottom

    • Remove screws from both sides of unit (4 screws total)

  2. 2LnUrCd4KmxovmVk
    2LnUrCd4KmxovmVk
    KAaWoZZLJQbIWwJ5
    • Remove both side panels from unit. You can pry them off with your finger nail or a spudger

  3. B3UA4EhTtsUA22BH
    B3UA4EhTtsUA22BH
    NcF2bSiuBJOMB5qv
    • Pry off rear cover. Make sure LCD remains in place.

    • There is a thin film of adhesive attaching the LCD to the rear cover. It releases easily with a little pressure. If necessary hold the LCD in place while removing the rear cover.

  4. I4dGUeFQV2qbKdWU
    I4dGUeFQV2qbKdWU
    lCxyWRqRG4dIdDOQ
    FDCRdKFcmtPZLGAL
    • Release the Ziff clamp holding the LCD cable. 1st photo shows clamp in closed position.

    • You can use a spudger to release the clamp. You can also use your finger nail, but be careful it is very fragile.

    • Remove the LCD Flex from the clamp

  5. OYZKAFdv3SXQVI3Q
    OYZKAFdv3SXQVI3Q
    1FP5wXbUS3yJQLUq
    SgcFR3nD43tqkLGl
    • You may need to pry off the window plate of your old screen if the new screen doesn't have one.

    • If required: Remove the window plate from your old screen if your new LCD doesn't have one. Save this part for re-install.

  6. f2RwG14HLNJwZOgP
    f2RwG14HLNJwZOgP
    SvtLOVKqo1ZpRLXW
    • If your new LCD does not come with a window plate: Tape your old window plate in place as shown in the photo. Make sure it lines up properly and fits into the grooves. This makes re-assembly much easier.

    • If necessary clean the window plate and LCD with a micro fiber dry cloth. Make sure there is no debris or dust before you re-install. DO NOT use any liquids.

    • Now just reverse the steps to re-assemble your camera with the new screen.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sales Cameraparts4you

Member since: 01/07/16

3150 Reputation

0 comments