Introduction

This repair is challenging because the wire that acts as the spring is difficult to bend into the correct shape.

  1. cas6Ym1bsyZhOhvc
    cas6Ym1bsyZhOhvc
    esiNZOrcYVRyOVpK
    • Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.

  2. fKH2aIprsLIjj3rX
    • Push the plastic push-down handle down and pull the plastic handle straight from metal arm.

    It really helped me to use a heat gun to warm up the handle a tiny bit.

    KC Embrey -

  3. tMLHBlhRqrivVWLZ
    • Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.

    • Only lift the outer shell a little so as not to disconnect the cables that connect the circuit board.

  4. jqfAdXcEnHW2Yllg
    jqfAdXcEnHW2Yllg
    BVQOZSvaw6JUYIcR
    • Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.

  5. KIuoITDCUvQcpOYH
    KIuoITDCUvQcpOYH
    2RG2cP3tBtfSSYN2
    • Lift the top outer metal shell.

    • Carefully lift the outer metal shell at an angle so as not to damage the components in the front of the toaster.

  6. xqE6Iv1oojJX5u3F
    • Press down on the toaster handle to access to the grabber spring located behind the large metal plate.

  7. Tt1aQTQW4RRJETTJ
    • Locate the grabber spring.

  8. c3ZDDfnkCCkIrvU5
    • Use the large needle nose pliers to unwind the grabber spring from one side of the carriage to remove.

    • Repeat this step for the opposite side.

  9. Ajj5HY6mQ4bVowht
    • Remove the old spring from the toaster unit to insert new.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Isaac Williams

Member since: 24/01/14

225 Reputation

0 comments