ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement

Written By: Emma Lucas
  • Comments: 0
ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement

Difficulty

Difficult

Steps

7

Time Required

40 minutes

Introduction

If the LEDs in your ORFELD EV-600's brush roller attachment have gone out, this guide will show you how to replace them. The LEDs in the brush roller are a useful tool for seeing while vacuuming dark spaces. Please use caution when using a soldering iron.

  1. XCnPGTAkmx6K6Gdc

    • Place the roller attachment bottom side up so you may access the brush.

    • Apply pressure with the iFixit opening tool to the tabbed side of the orange cap to release the roller brush.

  2. pZqJbN1x2CgVdHkU

    • Pull the roller brush from its socket one side at a time to remove it.

  3. 1iVFDbWSiAvNeFI6
    1iVFDbWSiAvNeFI6
    EOLkogOHGDQsBvpk

    • Remove the 11.5 mm screws surrounding the roller brush divot using a Phillips #0 screwdriver.

    • Remove the 11.5 mm screws located by the wheels using a Phillips #1 screwdriver.

  4. AAANCZ1nOfctyXPw
    AAANCZ1nOfctyXPw
    bpRvWKgYbYTRnvDD

    • Use the iFixit opening tool to pry the attachment open to pull the top free with your hands.

  5. WPn2vUEepYtabINV
    WPn2vUEepYtabINV
    MOtOVerZYQQnsMO2
    FBMrmCkuXO6BWIei

    • Pull the LED strip out with your hands or tweezers as there is a small hole at the top of the strip.

  6. jeVpIgeTdgo6hZn3

    • Use a soldering iron to remove the wires.

    • Please take proper precautions during soldering and hold the wires you are soldering with tweezers.

    • To solder the new board, make sure the red wire is on the LED side and the black one is on the side without LEDs.

  7. SabT2yapwATeSlEo
    SabT2yapwATeSlEo
    pBUqZSYtUQBIRRWC

    • Gently insert the new board. Make sure the LEDs line up with the little squares on the front of the roller brush. If it does not insert properly on the first try, keep adjusting.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Emma Lucas

Member since: 27/09/22

241 Reputation

0 comments