NuWave Brio 37001 Heating Plate Replacement

Written By: Michael Tucker

Comments: 0

NuWave Brio 37001 Heating Plate Replacement

Difficulty

Moderate

Steps

Time Required

20 - 25 minutes

Introduction

This guide demonstrates how to replace the heating plate in a NuWave Brio 37001 air fryer.

The NuWave Brio 37001 comes equipped with a metal heating plate, which can be located at the bottom of the device. The device's cooking basket rests upon this component when inserted. This plate is responsible for transferring heat generated by the coil. If it is faulty, it can lead to slow or uneven cooking.

Be sure to leave the device unpowered while following this guide. Touching an active heating element can cause injury.

Make sure you visit the troubleshooting page before following this guide. There could be issues other than the heating plate that need fixing.

Tools

Phillips #1 Screwdriver

Step 1

Unplug your NuWave appliance and ensure it has not been used within the last 20 minutes so that it is properly cooled down. Following this guide with an appliance that is still hot or powered on may result in injury.
Remove the basket from the NuWave's tray.

Step 2

Rest your appliance upside down, with the digital screen facing your work surface.
Take caution in flipping your appliance. Excessive force may cause components to break.
Remove the six 12 mm screws located around the edge of the bottom lid using a Phillips #1 screwdriver.
Remove four 10 mm screws using a Phillips #1 screwdriver.

Step 3

Use your finger to flip up each small metal tab located around the heating plate.
The plate may fall when all tabs have been flipped up.
Photos #2 and #3 both display an additional piece removed, which lines the edge of the basket area. Removing this is entirely unnecessary and included solely for the visibility of this guide.