Nostalgia Electrics RHP-310 Power Switch Replacement

Written By: Dana Clarke
  • Comments: 0
Nostalgia Electrics RHP-310 Power Switch Replacement

Difficulty

Moderate

Steps

6

Time Required

5 - 10 minutes

Introduction

If the device will not turn on or has a broken power switch, use this guide to replace the switch.

  1. EXxHyigiNay1KbNI

    • Unplug the popper.

    • Lift the lid up to remove it.

  2. Sk2mLMGtX3BFyIag

    • Lay the popper on its side.

    • Remove the five 12mm Philips #2 screws around the perimeter of the base with the Phillips #2 screwdriver.

    • Remove the two 15mm Philips #2 screws in the center of the base with the Phillips #2 screwdriver.

    • Put the removed screws in a safe place, they will be needed later to reattach the housing to the base.

  3. OOr3nmxYUA6ILjRV

    • Flip the base over to view the interior of the base panel.

    • Unscrew the two 10 mm Philips #2 screws from the base panel.

    • Remove the base and set it aside.

  4. XwiQIcGVxEOQcewd
    XwiQIcGVxEOQcewd
    nCZSOIRQBoRLfVBT

    • Locate the power switch connected to the side of the housing.

    • Pinch the sides of the power switch.

    • Push the power button up and out of the housing.

  5. wIdmPPc26XSJBNpi

    • Remove the wires connected to the power switch that should be detached from the housing.

    • Gently pry the wires loose from the power switch with the plastic opening tool.

    • The wires should easily pop out from the power switch.

  6. AsNWdq21gBqTFJOU

    • Remove the power switch from the housing unit.

    • You can now replace the power switch, if necessary.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Dana Clarke

Member since: 26/09/12

50 Reputation

0 comments