Nortel Networks i2004 IP Back Cover Replacement

Written By: Elizabeth
  • Comments: 0
Nortel Networks i2004 IP Back Cover Replacement

Difficulty

Easy

Steps

5

Time Required

10 minutes

Introduction

  1. HYGoXgxMmPaUi1Ls
    HYGoXgxMmPaUi1Ls
    eEHRMvFhOkjMP3QW
    SVtn2AaYUhVTrgkO

    • Flip the phone over to view the back.

    • Remove the power and phone cords.

  2. gCKcKKbUf1CZSeTj

    • Remove the seven 8mm Phillips #2 screws.

  3. YkCivGGjoANphGNi
    YkCivGGjoANphGNi
    b3MHThUbmViYFC1Q

    • Lift up the back cover slowly because there are still wires attached to the circuit board.

    • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

  4. EC5vCIjGyREmbRoc

    • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

  5. ADdeERYnPyoSTwb6
    ADdeERYnPyoSTwb6
    SY44DChUvI36cd4s

    • Remove the six 8mm Phillips #2 screws.

    • Pull the speaker phone cover straight up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Elizabeth

Member since: 21/01/12

160 Reputation

0 comments