Nokia 3.1 Battery Replacement

Written By: Baschtl
  • Comments: 2
Nokia 3.1 Battery Replacement

Difficulty

Moderate

Steps

4

Time Required

30 minutes - 1 hour

Introduction

This guide walks you through the process of replacing a worn out battery in a Nokia 3.1 smartphone. The process is quite straight forward. You only need some patience while removing the back cover as it might be hard to open it up at first.

You will need a model HE336 battery replacement.

  1. pVUyJHGTcpYfseuD

    • First, remove the SIM and SD card trays.

  2. Xl4YSogNuWQNiyBr
    Xl4YSogNuWQNiyBr
    ZhcADeqGgtEKHH4p
    fZYKXSykMX4COnwK

    • Try to use a thin tool like a razor blade to start to pry open the back cover.

    • When you opened it up just a little bit put a plastic card or a plastic opening tool inside the gap.

    • Using the plastic tool slowly make your way around the back cover. You can also use a guitar pick or similar.

    • Hint: the back cover is attached to the body with several plastic noses as well as a thin strip of adhesive. The cover is quite flexible and sturdy.

  3. PSpTd5xIwTvYJDHI
    PSpTd5xIwTvYJDHI
    cCKLPkvBq2oPC4Gd

    • Remove the seven Torx T5 screws from the logic board cover.

    • Remove the logic board cover.

    • Lift up the battery connector from the logic board.

  4. kr2RxtleEEd12HYQ
    kr2RxtleEEd12HYQ
    WWeEPpZkm15ZD1ZL

    • At the bottom end of the battery you will see two black ends of adhesive strips showing up from underneath the battery.

    • Slowly pull at those adhesive strip ends to be able to lift out the battery.

    Much as on some iPhones, the glue strips are hard to pull out, so warm up the phone by putting it screen-down on a hot bean bag or a bag of rice, which softens them a lt. They stretch a lot as you pull them, expect them to pull out to a good 25cm. Make sure you hold on to the battery as you pull it so as to avoid yanking on the connector when the glue lets go – or make sure you disconnect the battery first, as in the previous step.

    Marcus Bointon -

Conclusion

To reassemble your device, follow these instructions in reverse order. Also don’t forget some double-faced adhesive tape to fixate the new battery.

Author

Baschtl

Member since: 02/12/12

1525 Reputation

One comment

Merci beaucoup

GEORGES Sylvestre -