Nintendo GameCube Controller Back Panel Replacement

Written By: Jeffrey Hufford
  • Comments: 1
Nintendo GameCube Controller Back Panel Replacement

Difficulty

Easy

Steps

2

Time Required

1 - 3 minutes

Introduction

In this step we will be removing the bottom panel from the rest of the controller. This is necessary in order to access the inside components of the controller.

WARNING: Use caution when removing the bottom grip panel. Many of the buttons and components are held only loosely by the front panel and can fall out. Be sure to set screws aside carefully.

  1. dcSYZ1UnVsl6SqWL

    • Place the controller (buttons down) on a solid surface.

    • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

  2. SubSoUIKRilFSPLf

    • Gently lift the back panel up, separating it from the front panel.

    • Some of the buttons may fall out if they are knocked around.

    For some reason, it was simpler to take the top half off, although it could be because it is most probably refurbished before

    Rukir Gaming -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jeffrey Hufford

Member since: 18/01/13

142 Reputation

0 comments