Ninja Professional Blender BL660 Suction Cups on Base Replacement

Written By: Hernan Mendoza
  • Comments: 3
Ninja Professional Blender BL660 Suction Cups on Base Replacement

Difficulty

Easy

Steps

4

Time Required

5 - 10 minutes

Introduction

If the blender is too loud, the suction cups may be damaged or loose. This guide will help you to replace damaged suction cups.

  1. xtZGuLMF242t3COy
    xtZGuLMF242t3COy
    nyZJRZwO5yOfdJNC

    • Using the Phillips #1 screwdriver, remove the 5 screws holding the outer base.

    • Lift the base up to remove it.

  2. thJXJympYUpPGllw
    thJXJympYUpPGllw
    o1TSy134BhlInONK

    • Turn the base panel upside down to reveal the suction cup feet.

  3. GwmR1lLtc6PGilxr

    • Push the stopper on the suction cup foot through the bottom panel using the iFixit plastic opening tool.

  4. wv4bmiRGCSIEBDrG
    wv4bmiRGCSIEBDrG
    SMPnvCa5f6Kk1LLJ

    • Once stopper has passed through the bottom panel, pull suction cup foot out.

    • Replace suction cup feet as needed.

    • Ninja does not sell suction cup feet. You will need to obtain them from other third party vendors.

    I can’t find the suction cups for this blender. Can you recommend where to purchase

    Jan Schmidt -

    Same. Any ideas?

    Charles Baxley -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Hernan Mendoza

Member since: 22/09/17

201 Reputation

One comment

Where did you get the suction cups from?

camoramirez -