Introduction

Replacing the front cover of a Nikon Coolpix 3500.

  1. JSLtCtVWhsGQOH1e
    • Unlatch the battery cover and slide the cover out. Place cover to the side, it will not be needed for the next few steps.

    • Remove the battery.

    • Remove the battery cover without using excessive force. Keep in mind this cover is fragile.

  2. rw5KHCGPWr5XMWe6
    • Remove the two 4.5 mm screws that sit next to the battery slot.

    • Remove the 3 mm screw that sits below the CF card slot.

    • Remove the 4.5 mm screw that sits above the digital I/O cover.

  3. 6Pwua4XfjtVeatrL
    • Remove the two 4.5 mm screws that sit inside the battery slot.

  4. 13nu5ovLpdWBJTiU
    • Remove the two 5 mm screws that sit near the camera strap eyelet.

    • Remove the camera strap eyelet.

  5. t2FVJLJ4IC3NCgYA
    • Remove the 5 mm screw and cap that were underneath the camera strap eyelet.

  6. PcHGJb3GutQDKVWO
    PcHGJb3GutQDKVWO
    PWpUU1LkrIdDrQZ4
    • Remove the five 3.5 mm screws that sit at the bottom of the camera.

    • Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.

    • Do not apply too much force; two wires still connect the front cover to the motherboard.

  7. 3EZTBAU45ieGbM2Y
    3EZTBAU45ieGbM2Y
    LjioDeoNBeccyACg
    • Using a spudger, detach the white-capped wire.

    • Using a spudger, detach the orange-capped wire and set the front cover aside.

Conclusion

To reassemble your device, follow these instructions in reverse order.

richard guenther

Member since: 19/04/10

183 Reputation

0 comments