Nexus Q Inner Dome Daughterboard Replacement

Written By: Alex Thomas
  • Comments: 1
Nexus Q Inner Dome Daughterboard Replacement

Difficulty

Easy

Steps

6

Time Required

10 minutes

Introduction

Replace your worn out inner dome daughterboard: which contains Atmel ATMEGA328P, NXP Semiconductors 44501 Near-Field Communications Controller, TXC 8.00 MHz Crystal Quartz Oscillator, YF04E, and the status LED.

  1. JVOxILeWfJ1VclIQ

    • Squeeze and pull to pop the cap off of the Nexus Q.

  2. IP15HxMZTcIT1q2k
    IP15HxMZTcIT1q2k
    XcwUlHPFnvj5QvHc

    • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

    • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

    Why remove the anntenna? what did it do to you?

    rudyt83 -

  3. BVNeCPZTuCtTymNN

    • Undo the ZIF connector by prying with a spudger.

  4. INFPnnf3lnHAXiyh

    • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

  5. YWn6l2WAkN21FhZv

    • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

  6. LGZXQKgUFKUpZACE

    • Use a spudger to disconnect the daughterboard from the ZIF connector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Alex Thomas

Member since: 01/02/13

27 Reputation

0 comments