Introduction
This guide is used to replace the motherboard of the Nest Dropcam Pro if yours has stopped working. Make sure the device is unplugged before opening.
Tools
-
-
Lift the front of the case slowly, as there is an antenna cable attached to the motherboard.
-
Carefully disconnect the antenna cable from the motherboard. You will feel this cable "pop" out of place when disconnected.
-
-
-
Insert a spudger tool under the micro-USB port and lift to separate the motherboard from the back case.
-
-
-
Pull the motherboard away from the back case.
-
Unplug the red and black cable connecting the motherboard to the back case.
-
-
-
Lift the lens and LED assembly away from the motherboard.
-
Unplug the yellow and white cable from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
7 comments
where we can get the mother board to replace
I need this too
Where can I get the motherboard
xtogamba -
Can't find it either. Silly to write an entire article for credit if parts arent actually available.