Moosoo XL-618A HEPA Filter Replacement

Written By: Ashtyn
  • Comments: 0
Moosoo XL-618A HEPA Filter Replacement

Difficulty

Very easy

Steps

3

Time Required

40 seconds - 1 minute

Introduction

The HEPA (High-Efficiency Particulate Air) filter is a filter inside the microscreen filter in the dust seal of the vacuum that separates the dust particles from the dirt and grime. This filter needs to be replaced when it gets too dirty or damaged. Moosoo XL-618A troubleshooting recommends a replacement every two months. The first HEPA filter replacement comes with your initial purchase of the vacuum. After using this replacement, any subsequent filter replacements will need to be bought separately as needed. Here is a guide to replace the filter.

  1. 46DJ5FmppN1cpruv
    46DJ5FmppN1cpruv
    4UvuDluoRU2otFJS

    • Press the blue button on the exterior of the device to open the hatch.

    • If the seal contains debris or trash, be sure to hold it over a garbage can.

  2. GYVvNNDJcDCgChJK
    GYVvNNDJcDCgChJK
    dXXMQldVOfkMEq5F

    • Remove the microscreen filter by twisting it to the left and pulling it out.

    • Don't be alarmed if both filters come out together; the HEPA filter comes out very easily.

  3. awAVqgSgSNxytugy
    awAVqgSgSNxytugy
    iuWQIDFEYtZdP1ac

    • Pull the orange HEPA filter out.

    • When you reassemble the device, make sure the black ring on the filter is facing you.

    • The device comes with a replacement filter. However, you can buy more as needed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ashtyn

Member since: 20/09/23

489 Reputation

0 comments