Moosoo XL-618A Belt Replacement

Written By: tommygourley
  • Comments: 0
Moosoo XL-618A Belt Replacement

Difficulty

Moderate

Steps

6

Time Required

10 minutes

Introduction

If you are having issues with overall suction from the floor brush it may be a belt issue. Overtime the belt can become loose or broken down. Often they need to be replaced after a lot of use. The belt to the Moosoo XL-618A is a small flexible band that helps spin the floor brush. It also connects the brush to the motor, which makes the brush rotate. Here is a guide to replacing it and fixing it.

  1. sngfCOsKseYJqwgW

    • Remove the eight 11 mm screws on the bottom of the vacuum with the Phillips #1 screwdriver.

  2. qrnmcFxtuHghQFWJ
    qrnmcFxtuHghQFWJ
    LVXkfqrUMLUWTpAR
    YZtihrW6tSFVTeOb

    • Pull the two hard plastic covers off of the floor brush piece.

  3. tT3A6DPwrLMHb3Nb

    • Remove the 9 mm screw to the motor with the Phillips #1 screwdriver.

  4. UhVU14AXGvRbColg
    UhVU14AXGvRbColg
    rEgNCKJNraB6vnef
    4EGFd5FFa3VWZTUN

    • Take the motor and floor brush out of their slot and pull the floor brush off of the motor.

    • This is the perfect opportunity to clean the brush as well.

  5. mPbUrbHCLuGltmHa
    mPbUrbHCLuGltmHa
    IQTHRCTghUZIWYKx
    SlFm2COTQqanLjtv

    • Remove the two 9 mm screws with the Phillips #1 screwdriver and pull the plastic piece off of the motor.

  6. oDnd3WboCIanlJBf

    • Take the plastic piece and pull the belt off of the wheel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

tommygourley

Member since: 20/09/23

73 Reputation

0 comments