Introduction

This guide is used to explain how to replace the front camera on the Microsoft Surface Book 2 15. It uses the motherboard replacement guide as a prerequisite guide, which is a difficult task to perform.

The front camera replacement itself is a fairly simple one, that just requires detaching a ribbon cable and reattaching it. However, the steps before it where you open the laptop can difficult.

A majority of the issues that are found with the Microsoft Surface Book 2 15 can be solved through software solutions. Therefore make sure to review troubleshooting page and trying the solutions listed their before making any repairs to the device.

  1. UGFhYBQtLRXkISY5
    • Open the laptop, then orient it towards yourself.

    • Count from the bottom up by six holes on the tablet portion of the laptop.

  2. pXKljvK2S3rgnaFj
    pXKljvK2S3rgnaFj
    1tbfXxjSaHCsXjXG
    • Take a paper clip and unfold it.

    • Place the paperclip in the sixth hole and push until you hear a click.

    • Once you hear the click, lift up on the right side of the tablet from the base until it separates.

    • After the right side has been detached, lift up the left side as well.

  3. IQZUjPrnCHjeHAOL
    • Place the tablet on a flat surface.

    • Using a heat gun or iOpener, heat up the edges of the screen to soften up the adhesive.

  4. EShIpYK6IeRLAadf
    • Using a plastic pick, slice underneath the edge of the screen.

    • Use a suction cup to carefully lift the screen and create separation between the screen and frame.

    • Take care not to insert the tool too far to avoid cutting the ribbon cables.

    • Slowly make your way around the screen, and carefully cut the adhesive that secures the screen to the frame.

    • Don't use a metal tool, that could damage the screen or internal parts.

  5. YZcSaSFyrhRYYoVZ
    YZcSaSFyrhRYYoVZ
    MSdskRofqXe3QZZQ
    • Lift up the screen.

    • Detach the ribbon cables connected from the screen to the motherboard on the underside of the screen.

  6. t2RBIMmlH25YoPvc
    t2RBIMmlH25YoPvc
    AhFwjb5Ny1MSYhLP
    • Use a T3 Torx screwdriver to remove eleven 4 mm screws from the motherboard.

    • Use a T3 Torx screwdriver to remove the ten 2.5 mm screws from the top bar.

  7. oERBqLE36rCyW4Ec
    • Once the screws are removed from the top bar, gently lift up and remove it.

    • Be careful not to damage any ribbon cables or wires.

    • Gently lift up on the motherboard to remove it.

  8. YBpheH2VqlxZMYPL
    • After lifting the motherboard, locate the two cameras near the center of the motherboard.

    • Unplug front camera (right side) from the motherboard (lift carefully).

Conclusion

To reassemble your device, follow these instructions in reverse order.

Colton Almeida

Member since: 13/03/23

172 Reputation

0 comments