Makita Jack Hammer HM1203C 2010 Power Cord Replacement

Written By: Adam O'Camb

Difficulty

Moderate

Steps

Time Required

10 - 30 minutes

Introduction

Use this guide to replace the power cord in a Makita Jack Hammer HM1203C 2010.

Swing the bottom of the handle cover away from the hammer, then pull the cover down, toward the power cord, to remove it.

Use a Phillips #2 screwdriver to remove the screw securing the power cord bracket.

Lift the bottom edge of the bracket away from the hammer slightly, then pull down to remove it.
During reassembly, make sure the top hooked part of the bracket is inserted properly into its slot.

Use a 2.5 mm flathead screwdriver to loosen the two set screws holding in the power cord wires.

Use 10 gauge wire strippers to strip about 1/8 inch of insulation off of each wire of the new power cord.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Member since: 11/04/15

195421 Reputation

What does the flashing red indicator light indicate specifically? The green light is on but the red light underneath is also flashing.