MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement

Written By: Walter Galan
  • Comments: 0
MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement

Difficulty

Moderate

Steps

2

Time Required

No estimate

Introduction

This guide is an internal guide that is used only as a prereq.

  1. BjEhuZSCM6qDvtOG
    BjEhuZSCM6qDvtOG
    AoZo3p4ReDAryoZy

    • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

    • Pull the connector parallel to the face of the logic board, not straight up.

    • Use the flat end of a spudger to pry the Bluetooth antenna cable from its socket on the board.

  2. 42OXCYCdqbEFkxvN
    42OXCYCdqbEFkxvN
    OP5kNVsWUWdMJox1

    • Remove the two 8 mm Phillips screws securing the Bluetooth/camera cable retainer to the upper case.

    • One of the screws may remain captive in the Bluetooth/camera cable ground loop. If replacing the display, be sure to transfer this screw to the new unit.

    • Lift the Bluetooth board/cable retainer assembly out of the upper case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Walter Galan

694047 Reputation

0 comments