Logitech MX Master Side Feet Removal

Written By: Clay Eickemeyer
  • Comments: 0
Logitech MX Master Side Feet Removal

Difficulty

Easy

Steps

4

Time Required

No estimate

Introduction

This guide demonstrates how to remove the side (left and right) mouse feet to access the lower panel screws in your Logitech MX Master mouse.

  1. jlpSQPjdvdP251lj
    jlpSQPjdvdP251lj
    FjCXniWMT6QKcmGf

    • Flip the mouse's power switch into the OFF position, unplug any cables, and flip it over so the feet are facing up.

    • The unique shape of some mice can prevent them from laying flat. If you need to, lay your mouse on a soft towel to prevent wobble.

    • If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed.

    • Apply a heated iOpener to the left and right mouse feet for about one minute each.

    • Alternatively, you can use a hair dryer to soften the mouse feet adhesive.

    • When using a hair dryer, don't heat the feet for more than a couple seconds at a time—anything hotter than just warm to the touch risks melting or warping the plastic lower case.

    • The information sticker adhesive may soften during this step, but you don't need to remove it.

  2. BolO4m2ahoHDJ15L
    BolO4m2ahoHDJ15L
    rLBERyEUAfmIqcIa
    JiiJluMPwKyGRQj1

    • Insert an opening pick between the left foot and the lower case.

    • Go slowly, and make sure the pick slides underneath both the foot and its adhesive pad. These layers separate easily.

    • If you plan on reusing your mouse feet, be careful not to crease them or separate them from their adhesive pads.

    • Slide your pick under the foot to separate its adhesive until you can grab it with your fingers.

  3. sjkgwfjGxVfx6RLQ
    sjkgwfjGxVfx6RLQ
    GyJDkC3RrhN5tAnL

    • Peel up and remove the left mouse foot.

  4. LwKsJWXC2Gglh3Df
    LwKsJWXC2Gglh3Df
    DiITCjRmmBominZs
    yi6r1yJV6JDTqjqU

    • Insert and slide your opening pick under the right foot to separate its adhesive.

    • Remove the right mouse foot.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Clay Eickemeyer

Member since: 19/09/22

65190 Reputation

0 comments