Logitech MX Master 2S Side Feet Removal

Written By: Clay Eickemeyer
  • Comments: 0
Logitech MX Master 2S Side Feet Removal

Difficulty

Easy

Steps

4

Time Required

No estimate

Introduction

This guide demonstrates how to remove the side (left and right) mouse feet to access the lower panel screws in your Logitech MX Master 2S mouse.

  1. jaRAiBp2UGYCTMIn
    jaRAiBp2UGYCTMIn
    X2biTobEGlYIQI34

    • Flip the mouse's power switch into the OFF position, unplug any cables, and flip it over so the feet are facing up.

    • The unique shape of some mice can prevent them from laying flat. If you need to, lay your mouse on a soft towel to prevent wobble.

    • If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed.

    • Apply a heated iOpener to the left and right mouse feet for about one minute each.

    • Alternatively, you can use a hair dryer to soften the mouse feet adhesive.

    • When using a hair dryer, don't heat the feet for more than a couple seconds at a time—anything hotter than just warm to the touch risks melting or warping the plastic lower case.

    • The information sticker adhesive may soften during this step, but you don't need to remove it.

  2. uSOCf3sOABywXIdS
    uSOCf3sOABywXIdS
    2ONuboFVmRDBU2VX
    h3i5DjgDxStXPvRF

    • Insert an opening pick between the left foot and the lower case.

    • Go slowly, and make sure the pick slides underneath both the foot and its adhesive pad. These layers separate easily.

    • If you plan on reusing your mouse feet, be careful not to crease them or separate them from their adhesive pads.

    • Slide your pick under the foot to separate its adhesive until you can grab it with your fingers.

  3. SxSReKqTERMWKToL
    SxSReKqTERMWKToL
    VGo2EZARRhkMkX3R

    • Peel up and remove the left mouse foot.

  4. slNWNVDM41SBwx1a
    slNWNVDM41SBwx1a
    vIyoRtbN6IqJxkyd
    SOXDP6y2MUKvjDYx

    • Insert and slide your opening pick under the right foot to separate its adhesive.

    • Remove the right mouse foot.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Clay Eickemeyer

Member since: 19/09/22

65190 Reputation

0 comments