Introduction
Tools
-
-
Unfortunately, the left mouse button was 2x "sucked out" (button & the plastic pin over it)
-
Solution: Swap the button on the left with the mouse wheel button and - n small piece of office clip - for reinforcement - melt into the bottom of the pen.
-
YahooOoO - Looift widerer! Addendum: "mouse wheel click" Works by the way also - because there small springs ensure that the button does not "stick" in the pressed state
-
-
-
The plastic holder of the mouse buttons is loosened by carefully pressing the two plastic closures in the middle.
-
The motherboard is just plugged in and can be carefully removed forwards and upwards.
-
-
-
Sensibly, first clean everything (dry).
-
Now click the button for "Links" with the button below the mouse wheel. The solder joints are huge and easy to get even for beginners.
-
Repeat the steps in reverse order to reassemble your device.
