Logitech G903 Main Mouse Feet Replacement

Written By: Dominik Schnabelrauch
  • Comments: 0
Logitech G903 Main Mouse Feet Replacement

Difficulty

Easy

Steps

3

Time Required

No estimate

Introduction

This guide is part of another procedure and is not meant to be used alone.

Prerequisite-only guide to remove the main mouse feet of the Logitech G903.

  1. dpwfmyVuYhp3AA2t

    • If you’re planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated to cleanly remove them.

    • Heat an iOpener and apply it to the bottom mouse foot for two minutes.

    • A hair dryer or heat gun may also be used, but be careful not to overheat the mouse—the internal battery is susceptible to heat damage.

  2. Yy6DLWPtFyDf1hsw
    Yy6DLWPtFyDf1hsw
    IuPQTLKVJxWHbgDa
    PuWRTyRlAjTQxCvJ

    • Slide an opening pick under an edge of the bottom mouse foot.

    • Go slowly, and make sure the pick is underneath both the foot and its adhesive layer if you want to reuse the foot. It's easy to separate the foot from its adhesive.

    • If the foot feels stuck, apply more heat before continuing.

    • Slide the pick under the rest of the foot until you can lift it off the mouse.

    • Remove the foot.

  3. slgxho4yF5HYNjtA
    slgxho4yF5HYNjtA
    BMHejkNLEXeNmRIk
    6Djfu46upT3YNSHC

    • If the adhesive separated from the foot:

    • Slide the flat end of a spudger under an edge of the adhesive. If the adhesive seems stuck, you may need to heat the adhesive further.

    • Peel the adhesive off.

    • Before installing new feet or reinstalling old ones, wipe away any adhesive residue from the mouse with a lint-free cloth and high-concentration isopropyl alcohol.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Dominik Schnabelrauch

Member since: 23/11/16

201162 Reputation

0 comments