Introduction

Use this guide to remove or replace the back cover on a Lenovo Legion 5 17ACH6H laptop.

Before you perform this repair, be sure to completely power off and unplug your laptop. Make sure the laptop is not in standby, sleep, or hibernation mode.

  1. GeTmhSVUfTgYgjaS
    GeTmhSVUfTgYgjaS
    JUSXjaFGPJoDYMhg
    • Use a Phillips #1 screwdriver to remove the following ten screws securing the back cover to the frame:

    • Six 12.8 mm PH1 screws

    • Four 4.6 mm PH1 screws

  2. KKcoImdxhh35LQa6
    KKcoImdxhh35LQa6
    PXJT3foF1EXFUQFl
    OT14Xm4vwYAcLIqu
    • Insert the rounded edge of an opening pick between the back cover and the frame in the lower right corner.

    • Angle the pick to about 45˚.

  3. 4dPNpxdgdftsPVaE
    4dPNpxdgdftsPVaE
    hKqDMMYNJGMhHDNM
    h5qQEPP6wqoASVHS
    • Slide the pick along the front edge to release the clips securing the back cover to the frame.

  4. DUfLVctxsG5BVNTB
    DUfLVctxsG5BVNTB
    bRQhL1MmdZHOpY4K
    HGofMtHJF2GcByP2
    • Insert the edge of an opening pick between the back cover and the frame on the right edge.

    • Angle the pick to about 30˚ and slide down the left edge to release the clips.

  5. GVVtgxMSmScAS1hK
    GVVtgxMSmScAS1hK
    ZDaJW1cLeH6oFe6S
    at3QnJ2DEr2yhn4h
    • Repeat the same procedure on the left edge to release the clips.

  6. V4wAFEAecfXjtIdE
    V4wAFEAecfXjtIdE
    LdRZGfjIfmNR5J5a
    3TB4UebQnaCeRNxh
    • Slide the opening pick between the frame and the plastic vents on the right side near the USB-A port.

    • Rotate the pick so that it is positioned on top of the plastic vents.

    • If the pick is difficult to insert, position the laptop vertically to reduce the weight on the back cover.

  7. kDgHXRFnTYhtaali
    kDgHXRFnTYhtaali
    6CrLASj6XkwPWV5m
    • Push the pick between the frame and plastic vents.

    • Slide the pick along the top edge of the plastic vents to release the clips.

  8. w3IS4BKbOFTOWPgk
    w3IS4BKbOFTOWPgk
    dSISFpWFIGmIXKAI
    iSDNmSi14P1LAGBf
    • Slide the opening pick between the frame and the plastic vents on the left side near the USB-C port.

    • Rotate the pick so that it is positioned on top of the plastic vents.

    • Push the pick between the frame and plastic vents.

    • Slide the pick along the top edge of the plastic vents to release the clips.

  9. ZtyQGYu1DStBvm5f
    ZtyQGYu1DStBvm5f
    MZONTpkBNHpZ5YG2
    ZcLGvku4xqBQ2PjA
    • Lift the back cover up and remove it from the chassis.

    • During reassembly, this is a good point to power on your laptop and test all functions before sealing it up. Be sure to power your laptop back down before you continue working.

    Many Thanks !

    Without your help I wont have been able to open my Lenovo Legion 5 17ACH6 … most difficult to open laptop I encountered until now, especially the clips on the right and left vent.

    MEX -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Lenovo Legion answers community for help.

Chayton Ritter

Member since: 21/08/20

17428 Reputation

0 comments