Introduction

If your Kurio Xtreme's speakers are not working properly, follow these steps to replace the faulty speakers with new speakers. Before proceeding, make sure that you have a soldering iron and know how to use it.

  1. uoQkCFRnIFyJNyPD
    • Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

  2. niYVCXO2jewL6Nf6
    niYVCXO2jewL6Nf6
    c1Btbq2bLDToS2Na
    • Unscrew the four 4 mm black screws using a Phillips #000 screw driver.

    • There are two screws on each side of the device (four total).

  3. b5CSUCmbJMBJMOOh
    b5CSUCmbJMBJMOOh
    jxxZsbnUyQthS1pZ
    jYyRWipttPbUYf1i
    • Insert the plastic opening tool in between the edges of the blue front casing and black back casing.

    • Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.

    • Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.

    • Carefully lift the back panel off of the rest of the device.

  4. VjD2p3DlfpWRkZuA
    VjD2p3DlfpWRkZuA
    HpJ4r46TCMJM6FVU
    • Disconnect the 2 sets of black and red wires (4 wires total) from the motherboard by soldering the ends connected to the motherboard.

    • The soldering iron gets very hot and may injure you if exposed to your skin.

  5. AWVyhTogOQjBOpSe
    • Carefully remove the speakers out of the plastic molds by lifting up the black and red wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mallory Myers

Member since: 23/09/15

1190 Reputation

0 comments