Introduction

If one or both of the cameras in your Kurio Xtreme are broken, follow this guide to replace them. The front and back cameras are connected, so you will be replacing both of them, even if only one is broken.

  1. uoQkCFRnIFyJNyPD
    • Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

  2. niYVCXO2jewL6Nf6
    niYVCXO2jewL6Nf6
    c1Btbq2bLDToS2Na
    • Unscrew the four 4 mm black screws using a Phillips #000 screw driver.

    • There are two screws on each side of the device (four total).

  3. b5CSUCmbJMBJMOOh
    b5CSUCmbJMBJMOOh
    jxxZsbnUyQthS1pZ
    jYyRWipttPbUYf1i
    • Insert the plastic opening tool in between the edges of the blue front casing and black back casing.

    • Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.

    • Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.

    • Carefully lift the back panel off of the rest of the device.

  4. IaaZFE1rfVvE2Xir
    • Remove the flat-topped connector that connects the cameras to the motherboard by using the plastic opening tool to pry up on each side.

  5. hCP6vydV5suoEqPv
    hCP6vydV5suoEqPv
    aSCJFMmyN41FZGto
    vekcjtgKZpNRULRn
    • Remove the smaller, front facing camera by lifting up on the attached ribbon cable.

    • Remove the larger, rear facing camera by lifting up on the attached ribbon cable.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mallory Myers

Member since: 23/09/15

1190 Reputation

0 comments