Kurio Touch 4S Power Button Replacement

Written By: Moin Khan
  • Comments: 0
Kurio Touch 4S Power Button Replacement

Difficulty

Moderate

Steps

12

Time Required

10 - 20 minutes

Introduction

  1. vgI2vliFtFWkXEhP

    • Make sure to open the back cover easily using the plastic opening tool.

  2. dRJXETSgguJ42SVE
    dRJXETSgguJ42SVE
    ULQBhNgnlpWibhGk
    aX2Sb5Xn51vm5fZX

    • Remove back cover by prying away from the device.

    • The easiest place to remove the cover is from the bottom and top; try to open it from the right and left sides.

    • Open it gently. Do not open it with too much pressure, so that the plastic back cover do not break.

  3. LLeWRRHOPZtZDkPk
    LLeWRRHOPZtZDkPk
    NYvWCkxvHgCBEpsK

    • To remove the battery, make sure the four 5mm Phillips screws on each side of your device is open using the Phillips #1 Screwdriver

    • After you remove your four 5mm Phillips screws, use your plastic opening tool to help you open the plastic cover of your device.

  4. LTQpspMxHeKiVwbm

    • After you remove your four 5mm Philips screws use your plastic opening tool to help you open the plastic cover of your device.

  5. ARgS2KsTEAIMCSwC

    • Separate the two halves of your Kurio Touch 4S and lay them besides each other.

  6. WdxZyEPKSlVwGZOB

    • Gently remove the plastic cover that is covering the camera.

  7. ODsrTGGpx2bVkYQC

    • Use Phillips # 1 screw to open the four 5mm Philips screws on the motherboard.

    • Open the screws gently and do not apply too much force as you could damage the motherboard.

  8. ykrBnC5aEyjfFcSp

    • Use the plastic opener to remove the battery.

  9. nr4fR2WH3oLo5AtV

    • Use tweezers to remove the black tape that is attached to the motherboard.

  10. 3J45Rw53ih4Wj1xI
    3J45Rw53ih4Wj1xI
    IDVAYjrxgpuAfB4x

    • Detach all the wire that are connected to the motherboard.

    • Detach the camera module and other components that are attached to the motherboard.

  11. KulXQACGemKwiNis

    • Remove the motherboard with the help of plastic opener.

    • Detach the power plug before you remove the motherboard.

  12. EVHPexH4RsAoDluT

    • Use tweezers to hold the power button and gently lift it up.

    • Replace the old power button with the new one.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Moin Khan

Member since: 21/01/15

234 Reputation

0 comments